gigasept® AF forte is an aldehyde-free preparation for cleaning and disinfection of rigid and flexible endoscopes as well as surgical instruments. gigasept® AF forte Our plus: aldehyde-free suitable for flexible and rigid endoscopes shortened action time in ultrasonic baths patented substance combination Application areas Cleaning and disinfection of flexible and rigid endoscopes, surgical instruments, anaesthesia equipment and breathing masks. Instructions for use gigasept® AF forte is a concentrated product and is diluted with cold water to the desired working concentration. Reprocess flexible endoscopes with an application concentration of no more than 2%! Dosage: Depending on the degree of effectiveness 0.5 % – 5 %. Application example: 1 litre of a 5 % working solution corresponds to 950 ml of water and 50 ml of gigasept® AF forte. Immerse instruments to be reprocessed into the gigasept® AF forte solution immediately after use. Make sure that all surfaces are completed wetted and allow them to soak in the solution. Submerge instruments with a hollow body such that the air can fully escape from the lumen. After use, thoroughly rinse/flush the instruments with water that has at least drinking water quality, or better yet with sterile distilled or demineralised water, to remove any residues of the working solution. Do not exceed indicated contact times and concentrations. Please note the treatment recommendations provided by the instrument manufacturers. National regulations may require that cleaning and disinfection are carried out in two separate process steps. Not suitable for the final disinfection of semi-critical and critical medical devices! Standing time: A standing time of 7 days applies if the working solution is only used for the disinfection of previously cleaned instruments. If the working solution is used for cleaning, national regulations may limit the timespan during which the solution may be used. Microbiological efficacy Concentration Contact time bactericidal EN 13727, EN 14561 in accordance with VAH - dirty conditions yeasticidal EN 13624, EN 14562 in accordance with VAH - dirty conditions mycobactericidal EN 14348, EN 14563 in accordance with VAH - dirty conditions virucidal against enveloped viruses (incl. HIV, HBV, HCV) EN 14476, EN 17111 - dirty conditions virucidal against enveloped viruses (incl. HIV, HBV, HCV) in accordance with DVV (German Registered Association for Combating Viral Diseases)/RKI Guideline Rotavirus EN 14476 - dirty conditions Adenovirus in accordance with DVV (German Registered Association for Combating Viral Diseases)/RKI Guideline Polyoma SV40 in accordance with DVV (German Registered Association for Combating Viral Diseases)/RKI Guideline Ultrasound bath (bactericidal, yeasticidal, mycobactericidal, virucidal against enveloped viruses incl. HIV, HBV, HCV) Certificates • IHO listed • VAH certifica

gigasept® AF forte Product data Composition: 100 g agent solution contains the following active ingredients: 10 g Dimethyldioctylammonium chloride, 15 g Phenoxypropanols, 15.6 g Alkylguanidine acetate, 9.5 g Laurylpropylene diamine. Chemical-physical data Color Density Flash point Form pH Viscosity, dynamic green approx. 0.99 g/cm3 / 20 °C 62 °C / Method: DIN 51755 Part 1 liquid 9.8 – 10 / 20 °C approx. 60 mPa*s / 20 °C / Method: ISO 3219 Delivery form gigasept® AF forte 2 l-bottle gigasept® AF forte 5 l-canister These products are not available in every country. For more information please contact...