IPV®-2C Quick Reference Guide Before you start Assembling Phasitron Place a maximum of 20 ml of normal saline and/or medication (as prescribed by physician) in the nebulizer bowl. Connect yellow tubing quick-connect fitting to nebulizer bowl. Connect clear tubing quick-connect fitting to the cap. Press red tubing onto connector. Connect blue corrugated tubing to exhalation port. Connect the tubing to the corresponding-colored connectors. Do not obstruct green remote port. Patient Connections Mouthpiece Instruct patient to keep lips and cheeks splinted to ensure the pulses are directed into the lungs. It is recommended to use a resuscitation mask or similar nonvented mask. Direct The Phasitron can be attached directly to a patient’s tracheostomy.* NOTE: For patients under five years of age without an artificial airway, mask configuration is recommended. * IPV therapy should only be used in spontaneously breathing patients. Ensure Master Switch is OFF. Then, connect the IPV® to a 50 psi gas source

O Master Switch turns the IPV®-2C controller ON and OFF. Q Operational Pressure controls the peak operating pressure of the entire unit. > Starting Position: Adjust according to patient population (see below) Q Inspiratory Flow determines the amplitude delivered to the patient during inspiratory time. > Starting Position: Rotate Fully to the right in the OFF position. Note: for patients coming off respiratory support consider starting with Inspiratory flow on (i.e. with the knob's arrow straight up) and quickly titrate to target the MAP delivered from previous support. O Frequency controls the...

Workflow Ensure O MASTER SWITCH is OFF. Then, connect the IPV® to a 50 psi gas source. Then, turn the Master switch and Nebulizer ON and listen for flow. Patient Settings * IPV therapy should only be used In spontaneously breathing patients. NOTE: Before administering IPV® therapy, ensure knobs are in their recommended starting positions. NOTE: It is recommended to perform therapy for 15 to 20 minutes every 6 or 8 hours, or per provider orders. Patient should be monitored throughout therapy. NOTE: It is recommended to perform a pre-use check of device operation before attaching the Phasitron...

Digital Display Troubleshooting Digital display off To wake the digital display, turn the device ON and occlude the end of the Phasitron. Set the Operational Pressure and increase the Inspiratory Flow. Then allow a pressure reading to be registered. Check connections and/or digital display battery. Nebulizer not aerosolizing Ensure there is liquid present in the nebulizer bowl and check for flow out of the nebulizer. Disconnect the yellow tubing and verify flow. If flow is present, turn the Master Switch to the OFF position and reconnect the yellow tubing to the nebulizer bowl. If the issue persists,...