XFT-8006 Insole Plantar Pressure Feedback System
1Pages

Insole Plantar Pressure Feedback System I XFT-8006 I XFT-8006 Insole Plantar Pressure Feedback System mainly consists of an insole pressure sensor, a transmitter and a remote control. The product is suitable for lower limb rehabilitation training after lower limb injury or surgical. By using this device, doctors can monitor the patient's walk training by p re-set a pressure value. We also can use this device to test the patient's stride frequency, pace; During rehabilitation training session, when the patient's foot force has reached the doctor's preset pressure value, the remote control will alarm the patient to reduce the foot force. Under the protection of this device, we use the progressive rehabilitation training method to prevent and reduce the incidence of complications; it is good for bone injury healing, greatly improving the efficiency of postoperative patients' lower limb rehabilitation. ■ Through adjust the numeric of the pressure, it can improve the efficiency of the walking training and limb rehabilitation. ■ The design is delicate; it is convenient to install and carry. ■ Can detect the patients stride frequency and pace, which is good for the doctor to do gait analysis. ■ Seamless Bluetooth connection and LED icon indication. Plantar Pressure Alarm 1) During the patient walking, if the suffering leg's plantar pressure value is 010 (same as the setting value 010) or more (but less than 013), remote control will alarm a 'Beep'; 2) If the pressure value is 013 or more (more than the setting value 30%), remote control will alarm three 'Beeps' in a time. Stride Frequency Detection 1) Enable patients to stand up, Press 'stride frequency' button on the remote control to enter the stride frequency detection mode; 2) Patient begins to walk; the detection work will be finished while the patient's suffering leg has walks 12 steps. Then: 3) The stride frequency values will automatically display the remote control, such as display 110; it means that the stride frequency Insole Plantar Pressure Feedback System Pace (Step-speed) Detection 2) Enable patients to stand, press the button "Pace" on the remote control meanwhile the patient begins to walk. When the patient has completed 10m footpath, press "Pace" button again to end detection. 3) The remote control will display the value of the pace, such as '080', it means that the pace is 80 m / min. Clinical Application Procedure Note: Because of differences between individuals, the doctor should base on their clinical experience to test the setting value over and over again in order to set an alarm threshold. Clinical Program If there is a postoperative patient needs to do weight training, and the doctor set a load alarm value 20. If there is one 'Beep' can be heard while the patient do the training, it means that the patient's trainingisinan appropriate weight-bearing status. If there is no 'Beep' to prompt, it means that the patients' plantar force is not enough, and the plantar force should be increased; If there are three 'Beep' can be heard while the patient do the training, it means that the patient's plantar force is excessive and the force should be reduced. After a period of time rehabilitation training, the doctor can set a higher alarm valueforthe patient training untilthe patient recovery.