Ball Valve with Extensions Model SP150 Cleaned for medical gas use and 100% hydrostatic tested, these 3 piece medical gas valves are designed to meet the NFPA 99c, ISO 7396-1 & G-01 standards. Specifications ■ Valve shall be 3 piece ball-type full bore design, with a bronze/ brass body, stainless steel ball, stem, bolts & nuts. ■ Seat shall be Teflon (RPTFE) and seals Viton. ■ Valves ½” to 2” shall have a minimum pressure rating of 4137 kpa (600 psi) wog. Valves 3” to 4” shall have a minimum pressure rating of 2758 kpa (400 psi) wog. ■ Valve shall require only a quarter turn from fully open position to a fully closed position. ■ Extensions stubs shall be K type with a minimum 150 mm long to allow brazing without damaging the valve seat and seals due to heat transfer during brazing operation. ■ Each valve shall be hydrostatically tested for leakages. ■ Each valve shall be washed and degreased for medical gas use. ■ Pipe stubs extensions shall be capped at both ends. ■ The valves shall be supplied in sealed plastic bags, marked with “Oxygen” or “cleaned for oxygen use”, to prevent contamination prior to installation. ■ Valves shall be Silbermann model SP150 or equivalent. ■ All valves shall comply with NFPA 99, ISO 7396-1 & G-01 standards. Medical Gas System Standards: ■ NFPA99, EN ISO 7396-1 & G-01 requirements. Silbermann’s Quality Management System: ■ EN ISO 13485-2016 ■ The manufacturer reserves the right to make cha

Ball Valve with Extensions Model SP150 Catalogue Numbers SILBERMANN Technologies Ltd. Address: #5 Harakevet st. POB 4605, Petah-Tikva, 4900715, ISRAEL Tel: +972-3-9309186 | Fax: +972-3-9315721 E-Mail: [email protected], www.silbermnn.com