ELECTRONIC ROOM CONTROL MODULE - PH6010 ELECTRONIC ROOM AND LIGHTING CONTROL MODULE - PH6011 1 - Electronic module 2 - Electronic and lighting module 3 - Light diffuser 4 - Push-button for addressing room number DESCRIPTION Electronic room control modules PH6010 & PH6011 manage the information produced inside a given room and transmits it to the control station. The model PH6011 also controls the LED signalling for the module itself and the rest of the room. GENERAL FEATURES - It manages the information produced inside a given room and transmits it to the control station, and also controls the LED (model PH6011) signalling for the module itself and the rest of the room. - It can control and identify 2 beds per room, or more beds with room identification only. - Model PH6011 iIncludes LEDs in green, red and white. The LEDs indicate the type of call made: normal (red), bath (white), presence of nurse (green), emergency (flashing red and green) and bath emergency from the bathroom only (flashing red and green and continuous white). - There is a 15V dc connection for a buzzer to be used only where there is no speaker in the room, and whenever calls need to be received where a nurse is also present. - It also incorporates a push-button (4) for addressing room number TECHNICAL CHARACTERISTICS Supply voltage: 16VDC Maximum consumption PH6010: 37 mA Maximum consumption PH6011: 125 mA CONNECTION Before connecting the device, ensure that it is not connected to the mains supply. Insert the control in the support and connect up in accordance with the following instructions. TERMINALS 2 - Input +16V power supply 4 - Ground (cable at least of 1 sq mm) 7 - Room audio 7H - Floor audio CH+ - Floor bus CH- - Floor bus CE+ - Room bus CE- - Room bus L1 - Led Nurse/Doctor call P1 - Push button L2 - Led Presence / Cancel P2 - Push button L3 - Led Intercommunication cancel P3 - Push button L4 - Led Intercommunication control P4 - Push button L5 - Led Bed 1 call P5 - Push button L6 - Led Bed 2 call P6 - Push button L7 - Led Bathroom call P7 - Push button P8 - Push button General cancel VM - Microphone supply CT - Intercommunication control BZ - Buzzer connection WARNING: The system cabling should be installed separately from the mains electricity supply in accordance with regulations.

INSTALLATION EXAMPLES WIRING DIAGRAM 1: FITTING RECOMMENDATIONS: These modules can be placed on flush-mount boxes indicated below. It is required the front plate KM9200-01 also shown below. This frame is supplied separately. RECTANGULAR FRONT FRAME FOR SONELCO BOX or DOUBLE UNIVERSAL BOX: For correct fitting of the control, position the base plate as shown in figure 1, with the bent end towards the side where the control is inserted. In this position, fit the control module (1) onto the base plate (2), gently, until you hear a click. After making the connection and performing operation tests,...