Technical Data SheetStructure-Borne Sound Probe T10 The Structure-Borne Sound Probe T10 is used for condition monitoring of machines, plants and processes where detectable structure-borne sound in the ultrasonic range is generated. Changes in the sound signals indicate a change in the condition and/or process of the test object. The detection of these changes forms the basis for condition monitoring in preventive maintenance. The Structure-Borne Sound Probe T10 is used when the installation space is very limited or the test object must not be loaded with a large sensor mass. The Structure-Borne Sound Probe T10 is also suitable for use on non-magnetic surfaces. The type of coupling depends on the type of test. The probe can be coupled by hand for short-term measurements or fixed with beeswax for recurring measurements with recording of measurement data. For permanent monitoring or fixed mounting within a safety cover/zone, the probe is glued on. General data Dimensions (L x W x H) □ 11 x 9 mm (housing without connector) Electrical connection UNF 10-32 (Microdot) Acoustic data Sensitivity 6,0 mV / 1 m/s1 2 @ center frequency © The specified acoustic data apply from a frequency of 5 kHz.

Technical Data Sheet Structure-Borne Sound Probe T10 Housing Stainless steel Probe delay PEEK Ambient conditions Order details Scope of delivery • Structure-Borne Sound Probe T10 • Transportation case • Calibration certificate • Technical data sheet Frequency response

Technical Data Sheet Structure-Borne Sound Probe T10 Inspection method Short-term Recurring measurement Permanent monitoring/ measurement with recording of fixed mounting measurement data Couplant / coupling Grease (Vaseline), Beeswax Coupling oil or gel for ultrasonic testing Cyanoacrylate adhesive (e.g. Loctite 401) or grease (Vaseline), coupling oil or gel in combination with clamping mechanism Coupling method 1: Pressing on by hand 2: Fixing with beeswax 3: Gluing/ installing (short-term coupling) (long-term coupling) The coupling method has a significant influence on the measurement results!...

Technical Data Sheet Structure-Borne Sound Probe T10 Drawings are not to scale. Dimensions in mm, unless otherwise specified. Information is subject to change without notice. SONOTEC GmbH SONOTEC US Inc. Nauendorfer Str. 2 Phone: +49 345 13317-0 190 Blydenburgh Rd 06112 Halle (Saale) [email protected] Suite 8, 2nd Floor Germany www.sonotec.eu Islandia, New York 11749, USA