Incubator, SI60, SI60D
1Pages

{{requestButtons}}

Catalog excerpts

Incubator, SI60, SI60D - 1

Key Features Incubator, Constructed from clear Acrylic® polymer to give total visibility of samples at all times. Designed for easy access with hinged front door panel. Each side panel has 2 x 10mm diameter plugged holes for the introduction of either gases or cables. The incubator does not have a base so that it can be placed directly over complete instruments (base is available as an accessory). Forced air circulation and electronic temperature control ensure accurately maintained conditions. For analogue model SI60, setting the temperature is via a i calibrated knob. For digital model SI60D, setting the temperature is more accurately achieved via the LCD display. The latter also gives a constant reading of actual temperature. Both models have a push switch pre-set at 37°C. Additionally there is a temperature safety cut-out set at 72°C. The incubator is supplied flat packed, for assembly at point of use. Assembly is simple and requires only a screwdriver. Technical Specification Temperature range Ambient +5°C to 60°C Temp. variation between shelves ±0.3°C Nominal volume 60 litres Ordering Information Model Description SI60 Incubator, total visibility, analogue SI60D Incubator, total visibility, digital SI60/1 Acrylic® base plate SI60/2 Plastic coated shelf/rack system with two shelves Stuart® Catalogue

Open the catalog to page 1

All Cole-Parmer catalogs and technical brochures

  1. Homogenisers

    4 Pages

  2. SI505

    2 Pages

  3. Centrifuge

    4 Pages

  4. SB161-3

    1 Pages

  5. SRC4

    1 Pages

  6. SHM1

    1 Pages

  7. SHM2

    1 Pages

  8. Hotplates

    1 Pages

  9. SHM Probes

    2 Pages

  10. W6

    1 Pages

  11. HM Series

    1 Pages

  12. SBHCONC/1

    1 Pages

  13. SBH130

    1 Pages

  14. Mini Stuart

    4 Pages

  15. BioCote®

    3 Pages

  16. SI505

    4 Pages