PHYSIO LINE - Bipodal Stabiloscope – HQZ Tm Bipodal Stabiloscope - HQZ Tm Structure p No mains supply ; only 2 batteries of 1,5 volts located in the housing to the right of the control board p A frame to hold the patient in the shape of walking frame p Average height : 80 cm from the tray p Adjustable from + or – 10 cm depending on the patient’s height p Width (m) : 0,74 p Depth (m) : 0,70 p Average height (m) : 1,05 p Weight (kg) : 25 p Maximum user’s weight (kg): 110 Electronics Control board p Timer to set the exercise time between 0 and 30 minutes (average time for a session: from 3 to 10 mn). Its turns on the light beam and starts the counting of oscillations performed p A counter to total the cycles performed. After the oscillations are counted and the exercise is stopped, it is reset for the next cycle p A buzzer to indicate the end of one two-way cycle to the patient (especially for the partially sighted) p A switch to make the buzzer into operation p A light beam to view the movements made. It is adjustable to aim at one of the two targets Two viewing targets: p One horizontal on the control board for people with poor sight p One vertical to be hung on the wall close to the machine, allows normal horizontal vision Standards p Machine in compliance with EC Standards p Directive 93/42/CEE (concerning the medical devices) p Standards : EN 60204/1 – EN 60601/1 – EN 61000/6/3 – EN 61000/6/1 Guarantee p 5 years guarantee* Commercial department RN 6, route de St Bris • BP4 • F - 89290 Champs-sur-Yonne • Phone + 33 (0) 386 53 83 81 • Fax + 33 (0) 386 53 80 42 • [email protected] • www.techmed-tm.com (*) See General Conditions of Sale – Non-contractual document – REF 2012-B p A wide, low, easy-access, oscillating tray located at least 10 cm from the floor p Amplitude of oscillations : + or – 3 cm p Side, to-and-fro or overall oscillations Adjustment of the tray mobility: p A central handle to adjust the hardness p Increase by turning clockwise p Reduction by turning anti-clockwise Selection system for the direction of tray oscillations: p Sideways (right, left) by raising the adjustment handle located under the luminous point p To-and-fro (forwards, backwards) by raising the adjustment handle to the right p Overall by putting both handles in OFF position