IS75 Person Detection Beacon The IS75 Person Detection Beacon is designed to allow the locating of any person wearing a S37L Wristband Transmitter with Locating function in the nearby vicinity. It generates a coded magnetic field which can be identified by the S37L Wristband Transmitter with Locating function. This system may be used to locate patients suffering from Dementia and eventually prevent them from leaving the area alone. System Overview Passage marking and efficient locating of patients Reliable dementia monitoring Freedom of movement for the patient Guarantees fast intervention of staff Expandable system (one or more loop antennas) Main Unit / Relay Unit The IS75 Person Detection Beacon is built to interact with the following devices: • S37L Wristband Transmitter with Locating function • NurseCall Main or Relay Unit The system consists of the IS75 Beacon Controller and a loop antenna. By carrying out a loop with a simple wire, a coded magnetic field is generated. This loop antenna is connected to an IS75 Beacon Controller, and the system will send an identification code back to any S37L Wristband Transmitters with Locating function in the area. The S37L Wristband Transmitter with Locating function will automatically detect the IS75 Person Detection Beacon’s coded magnetic field. At alarm triggering, the S37L Wristband Transmitter sends the call for help to the NurseCall Main Unit along with its identification code as well as the position of the last passed beacon. The information may be used to locate the patient that has triggered a call for help, or send an alarm as soon as a “Dementia” patient is going through a monitored door. When passing each IS75 Person Detection Beacon, the S37L Wristband Transmitter refreshes its actual position. Therefore, the position recorded by the S37L Wristband Transmitter is always the one of the last passed beacon. The LED on the top of the housing indicates the status of

Technical Specifications Certifications and Approvals R&TTE 1999/5/EC EMC 2004/108/EC LVD 2006/95/EC EN 55022 (2006, A1: 2007) Quantity Component Do not install the beacon module in exposed sunlight or where there is poor air circulation. The IS75 Beacon Controller should be installed in a well-ventilated area, so as to avoid overheating. Use one loop antenna when using on doors (door width dimensions typically 1m to 1.5m). You can also install the loop antenna on the floor or on a wall. In that case, use a loop surface equivalent to the size of a door. If possible, avoid using on metallic doors....