TGM1series Product Segments • Ergo Motion • Industrial Motion TiMOTION's TGM1 series gear motor was designed primarily for ergonomic applications like height adjustable workstations and tables, but can be used in many other applications. This economical product allows for fast, smooth and quiet adjustment of built-in spindles through the use of external limit switches. Shafting allows for the mechanical synchronization of dual spindles. General Features 24V DC or 24V DC (PTC) 144RPM (±5%) after gear reduction 7.4Nm UL962 +5°C~+45°C Voltage of motor Maximum speed at full load Maximum rated torque Certificate Operational temperature range at full performance Options Hall sensors Hexagon hole for the shaft by 6mm diameter Low noise

Standard Dimensions -Without TES2 (mm) Standard Dimensions With TES2 (mm) Self Locking Force (Nm) Typical Current (A) Typical Speed (RPM, ±5%) Hall Sensor Output No Load With Load No Load With Load Magnet Period (ms) No Load With Load Note 1 Please refer to the approved drawing for the final authentic value. 2 The current & speed in table and diagram are tested with TiMOTION control boxes, and there will be around 10% tolerance depending on different models of the control box. (Under no load condition, the voltage is around 32V DC. At rated load, the voltage output will be around 24V DC)

Motor Speed (3800RPM) Speed vs. Torque Load 400 Current vs. Torque Load 10.0 Performance Data (24V DC Motor)

Motor Speed (3400RPM) Speed vs. Torque Load 400 Current vs. Torque Load 10.0 Performance Data (24V DC Motor)

Performance Data (24V DC Motor) Speed vs. Torque Load Current vs. Torque Load

0 = Without 2 = Hall sensor * 2 0 = Without 1 = Motor brake 0 = Tinned leads 1 = DIN 6P, 90° 2 = Molex 8P 0 = Straight, 1000 1 = Straight, 1500 2 = Straight, 2000 3 = Curly, 1000 1 = Drive shaft hole (inner hexagon 9) 5 = Drive shaft hole (inner hexagon 6) 00 = Without XX = Number of output rotations (between13~17 & 25~35 rotations, factory preset)

1 = DIN 6P, 90° plug 2 = MOLEX 8P, plug 50 Note 1 The combinations of TGM and TBS are marked as "v" on the above table. 2 When choosing the combination of TBS2 / 3 and TGM7, the hexagonal drive shaft is not required. 3 When choosing the combination of TBS1 / 4 / 5 / 9 / 10 and TGM1 / 3 / 4, the extra order of hexagonal drive shaft is needed. 4 Please refer to the table below for the serial numbers and the dimensions of the component. Hexagonal drive shaft The user is responsible for determining the suitability of TiMOTION products for a specific application. TiMOTION products are subject to change...