Lifting Devices - 2 Pages

Add to MyMedicalExpo favorites
Lifting Devices

Catalog excerpts

Lifting Devices Pool hoist model Pooli II type 1100 part-no. AL4060 for fixation purposes placed back from the pool edge, hoist for pools without parapet, however with overflow groove consisting of: 1 hoist column 360° swivelling, with extension arm and joint 220° hinged, floor board made of V2A stainless steel with swivel column, extension 650 mm as standard, other extensions possible (extra charge). 1 Lifting system for exchangeable coach and seat with electro-mechanical jog-free height adjustment, 1100 mm standard lift with electronic switch-off. 1 Mobile remote control with magnet holder. Currentless air-drive controller to activate electrical control for lifting and lowering „up - down“. Pooli II with seat 1 Emergency drop and emergency stop switch according to required standard 2 Batteries with 3 Ah storage capacity each, maintenancefree and discharge-protected. Only 1 - 2 loading cycles per week according to frequence of use. 1 Battery charger 230 V/24 V, water-proof, IP 65, electronically controlled overload protection and charge monitor lamp. Cable length 24 V: 2,5 m Cable length 230 V: 1,9 m 4 Chemical anchors UKA 3 for hard building materials, intended for floor fixation, including drilling stencil All metal parts plastic coated white RAL 9010. Technical specifications max. load standard hoist swivel range standard height of appliance control medium operating voltage Pooli II with couch Special dimensions on demand. Before delivery the following documents are necessary: ground plan with mounting place, sectional view of the pool with the water level, useable height to the ceiling and the floor construction. For the production we made a drawing which is subject to authorization. Not suitable for use in briny or salty water. Accessories: see overview sheet 14.04.01 and 14.04.02 special fittings and accessories. Pooli II with transport seat and mobile lower part Technische Änderungen vorbehalten Trautwein GmbH, 79312 Emmendingen Tel.: 07641/4677-30 Fax: 07641/4677-70 Internet: http://www.trautwein-gmbh.com

 Open the catalog to page 1

Lifting Devices Potentials usgleich Pool hoist On-site connections: 1. socket 230 V, 50 Hz, for charging device close to the hoist. Cable's length all over 4,4 m power supply via fuses (10 A) and protection switch 2. charging system 230/24 V (included) 3. fixed by 4 compound anchors UKA 3 M14. bore hole 0 16 mm, 110 mm deep in concrete. On-site safety measures Electric installation according to DIN IEC/VDE At order for the producion of the pool hoist an exact layout of the pool with dimensions of water level, possible handrails and the height of the room is required. Before drilling the...

 Open the catalog to page 2

All Trautwein catalogs and technical brochures

  1. Thermo-Spa

    2 Pages