Pool hoist model Pooli III type 1100 - 2 Pages

Add to MyMedicalExpo favorites
Pool hoist model Pooli III type 1100

Catalog excerpts

Lifting Devices Pool hoist model Pooli III type 1100 part-no. AL4070 for fixation on pools with parapet consisting of: 1 hoist column 360° swivelling, with extension arm and joint 220° hinged, floor board made of V2A stainless steel with swivel column for fixation on parapet, extension 650 mm as standard, other extensions possible (extra charge). 1 Lifting system for exchangeable coach and seat with electro-mechanical jog-free height adjustment, 1100 mm standard lift with electronic switch-off. 1 Mobile remote control with magnet holder. Currentless air-drive controller to activate electrical control for lifting and lowering „up - down“. 1 Emergency drop and emergency stop switch according to required standard 2 Batteries with 3 Ah storage capacity each, maintenancefree and discharge-protected. Only 1 - 2 loading cycles per week according to frequence of use. 1 Battery charger 230 V/24 V, water-proof, IP 65, electronically controlled overload protection and charge monitor lamp. Cable length 24 V: 2,5 m Cable length 230 V: 1,9 m 4 Chemical anchors UKA 3 for hard building materials, intended for floor fixation, including drilling stencil All metal parts plastic coated white RAL 9010. Technical specifications max. load standard hoist swivel range standard height of appliance control medium operating voltage Special dimensions on demand Before delivery the following documents are necessary: ground plan with mounting place, sectional view of the pool with the water level, useable height to the ceiling and the floor construction. For the production we made a drawing which is subject to authorization. Not suitable for use in briny or salty water. Accessories: see overview sheet 14.04.01 and 14.04.02 special fittings and accessories. Technical details subject to change Trautwein GmbH, 79312 Emmendingen Tel.: 07641/4677-30 Fax: 07641/4677-70 Internet: http://www.trautwein-gmbh.com

 Open the catalog to page 1

Lifting Devices Pool hoist model Pooli III type 1100 part-no. AL4070 On-site connections: 1. socket 230 V, 50 Hz, for charging device close to the hoist. Cable`s length all over 4,4 m Pay attention to VDE 0750! power supply via fuses (10 A) and protection switch 30 mA. 2. charging system 230/24 V (included) 3. fixed by 4 compound anchors UKA 3 M14. bore hole ∅ 16 mm, 110 mm deep in concrete. On-site safety measures Electric installation according to DIN IEC/VDE At order for the producion of the pool hoist an exact layout of the pool with dimensions of water level, possible handrails and the...

 Open the catalog to page 2

All Trautwein catalogs and technical brochures

  1. Thermo-Spa

    2 Pages