Pinch valve, valve housing from high performance plastic
2Pages

Product Information Pinch valve, valve housing from high performance plastic 2/2-way, NO (normally open) A.u.K. Müller Solenoid valves Control valves Special valves and systems A. u. K. Müller GmbH & Co. KG Dresdener Str. 162 D-40595 Düsseldorf/Germany e-mail: info@akmueller.de Internet: www.akmueller.de The valve with a valve housing made of a high-performance plastic is an inexpensive alternative to the valve types 16.003.225 with aluminum housing. In addition the valve offers the advantage of smaller height and lower weight. Typical Performance Curve Silicone tube 3x1; 60°Sh; length 30 cm (squeezed in the middle) Medium: Water at 25°C; Free Outlet The flow of the medium is controlled by pinching the inserted tube. This design avoids using the traditional valve seat and membrane which can cause turbulence in the fluid flow and create dead areas in the valve housing where medium or dirt can collect. The valve is particularly suitable for applications where a high level of hygiene is required. The pinch valves can be used in any mounting position. The resistance against media temperature and chemicals depends on the selected material of the tube. medium completely separated from valve parts chemical resistance depends on the material of the tube in use tube can easily be changed no dead areas as in usual valve body flow in either direction coil can be fixed in 4 x 90 ° positions function provides high reliability and run time dosage systems laboratory analysis medical equipment vending machines The 16.003.625 pinch valve series is normally closed in operation and equipped with a 9,5 W solenoid coil. Therefore, it exhibits a clamping force between 10 and 30 N per opening condition and is applicable for flexible tubes with a wall thickness of 1 mm with an outer diameter up to 5,0 mm and a shore hardness of 60°. With these tubing specifications, pressures up to 1,5 bar can be switched. © copyright A.u.K. Müller, technical changes reserved

A.u.K. Muller tightening torque max. 2 Nm aterials Valve body and PA 6, glass fibre reinforced fixing flange Plunger guide stainless steel Plunger and spring stainless steel with protective conductor system with reinforced insulation Range of possible outer diameter (O.D.0) of tube: 4,0 - 5,0 mm. The wall thickness should not deviate from the one given in the upper table. The valve may only be operated with inserted tube. E0623 © copyright A.u.K. Muller, technical changes reserved 2