Pure_Breeze_Fume_Hood
4Pages

PURE BREEZE FUME HOOD IMPORTANT SERVICE INFORMATION: SAVE SHIPPING BOX AND FOAM FOR FUTURE SERVICE. SHIPPING WITHOUT PROPER FOAM MAY CAUSE DAMAGE TO UNIT 1 - Pure Breeze Fume Hood 1 - Power Cord 2-Hood Skirt Sides 2-Hood Skirt Centers 4-Hood Skirt Corners 16-Hood Assembly Screws (6-32) 3-Hanging Eye Bolts 3-Eye Bolt Nuts 3-Eye Bolt Washers 3-Wall Mounting Screws 2-Rubber Feet with adhesive Components installed at factory 1 - Wall Hanging Bracket 6 - Hood Mounting Thumb Screws 2 - Hood Mounting Star Lock Nuts ASSEMBLY AND INSTALLATION INSTRUCTIONS 1. To remove the Fume Hood from the box, remove loose items, stand the box on end, open the flaps of the box and slide the unit out on its end. Remove the plastic bag and check all parts against the packing list. 2. The Fume Hood can be positioned over the work area three ways. Against a wall with the brackets provided, hung from the ceiling with the eyebolts provided, or by an optional bench stand (see application instructions below). The following must be considered when mounting the Fume Hood on a wall or from the ceiling. a. Wall Mount: Make sure the Fume Hood has at least three inches of clearance on each side for proper exhausting and access to the door latches. The studs of the wall should be able to support 100 pounds. b. When hanging from the ceiling: The ceiling members must also be able to support 100 pounds. Note: When installed over a furnace some precautions apply, see application instructions below for more information. 140 N. Brandon • P.O. Box 74, Fallbrook, CA 92028 • 1-800-VANIMAN (826-4626) • www.vaniman.com • sales@vaniman.com

PURE BREEZE FUME HOOD 3. Mounting the hood skirt to the case. (Figure A) The hood skirt can be configured to meet the mounting area requirements by just leaving the components out when assembling. Example: If the desired position is next to a corner using the wall mount, simply leave off the skirt parts from the back and desired side. a. Turn the unit over on the top or side being careful to protect the switches. b. Mount the hood skirt side(s) and hood skirt center(s) desired to the bottom of the body with the provided thumb screws and the star lock nuts on the exhaust side. c. Align a...

PURE BREEZE FUME HOOD with a washer in between the case and nut. c. The unit can now be hung from the hanging devices chosen. Note: Check local laws and regulations. If unable to install safely or if required by regulations, hire a certified technician to install the product. APPLICATION INSTRUCTIONS 1. The Fume Hood works well over a furnace or other heated device that produces smoke or fumes, A minimum distance of 4.0 inches is required between the heat source and the bottom of the case (not including the skirt). In most cases, the closer to this distance, the better the results as the...

PURE BREEZE FUME HOOD For your convenience Vaniman offers a filter package which includes three Pre-filters and one Secondary Filter. This filter package will enable you to replace your Pre-filters while reminding you of the three to one filter maintenance schedule. Order P/N 97025. c. The Charcoal Odor Filter or third filter can be determined by its metal frame. The Charcoal Odor filter is located on top of the group of filters inside the unit. This filter absorbs odors in the air; it is similiar to a chemical sponge used to collect chemicals that emit odors. The Charcoal Odor filter must...