Technical Datasheet Vena® FOOD Applications It is especially recommended for the transport of liquid or semi-liquid food products, even at high temperatures (milk, chocolate, mineral water, beer, alcoholic drinks, fruit juice, oil, cosmetic cream etc…) It is recommended especially when a smaller bending radius is required. These hoses are able to transport liquid or semi-liquid foodstuffs at high temperatures by impulsion or suction, since their design can resist pressure or vacuum. Respect the bending radius and work pressure established values. Mind the chemical compatibility of the fluid with butyl rubber Regulations Butylic rubber produced in compliance with: German BfR Standard part XXI Cat 2 Odorless, tasteless and completely non-toxic. White color and smooth inner appearance, purple colored and smooth outer appearance. Can be equipped with 316L stainless steel fittings on each end with a roughness value of less than 0.8 m (or 0.5 m on request). Operational temperature range from -20°C (4 F) to +100°C (212 F) it may reach up to +120°C (248 F). It can be sterilised at 130ºC (266 F) for a maximum time of 30 minutes. Available at a maximum length of 40m (131.23 ft) The vacuum resistance for this hose is 0.9 Bar (13.05 psi) up to diameter 63 (2 ½ inch) and 0.8 Bar (11.6 psi) from 63 (2 ½ inch) to 102mm (4 inch). 3A Sanitary Standard 18-03 Class III (hose) Butylic rubber used is in accordance with EU Directive 2002/95/ECC for Restriction of the use of hazardous substances (RoHS) Inner Diameter This product is manufactured with inner Butyl food grade and EPDM cover, it is equipped with two textile reinforcements inside the wall of the tube, a double steel spring wire and copper braiding which prevent users from discharges of static electricity. Technical Specifications Outer Diameter Contact your sales office for more informat

Technical Datasheet Vena® FOOD The extreme working conditions or the use of materials with low compatibility with the silicone can attack the inner surface of the hose. It is advisable to inspect the inner appearance for cracks or swelling, and replacement of the hose, if necessary. Hose cover: Should be inspected over the entire length for signs of hardening, abrasion, cuts, kinking or crushing. Contact your sales office for more information [email protected] – www.venair.com 2/2