HOW TO RESTORE A Z5-TL IMPLANT

Product catalog summary

Introduction
This document provides a detailed guide on restoring a Z5-TL implant, focusing on intraoral cementation and the use of specific components and procedures.

Intraoral Cementation Procedure

Insert the abutment into the implant body manually, ensuring it is fully seated using the internal hexagon.
Pack the screw channel with Teflon tape and apply cement on the final abutment, ensuring all excess cement is removed.
Connect the abutment and implant using an occlusal screw until the driver breaks.

Components and Tools

Various abutments and screws are available, including straight and angled Zloc abutments with different angulation heights (AH).
Use the laboratory screw "BL-OSL" for lab work, while "BL-OSC-H/OST-H" screws are for clinical use.

Recommendations and Limitations

Ensure no peri-implantitis, implant loosening, pain, or mobility before final prosthesis placement.
The crown should not exceed 10.5 mm in height above the implant shoulder, and the horizontal crown width should not exceed half the implant diameter overhang.

Multi-tooth and Bar Restorations

Stabilization and primary blocking of implants are crucial for securing the prosthesis against forces.
Force distribution and resilience compensation are achieved through degrees of freedom.

General Rules

Position implants parallel to each other, allowing a divergence of up to 7° for impression post withdrawal.

Additional Notes

Extraoral cementation is not possible.
Always refer to the Z5-TL user manual for comprehensive instructions.

Catalog excerpts

How to restore a Z5-TL implant Currently only possible with exocad Model Scanning Intraoral Scanning Impression coping Impression coping Intraoral Scanbody Open and Closed Tray Open and Closed Tray final abutment Implant Analog Implant Analog Implant Analog Insert the abutment into implant body by hand. The internal hexagon ensures the abutment is fully seated. or Impression Intraoral Tray Scanning Screws delivered with both screwdriver options For abutment removal, remove the screw using screwdriver SD-BS-S/L, then elevate the abutment with BL-CD. titanium ceramic BL-OST-H BL-OSC-H Connect abutment...

Open the catalog to page 2

Check before Final Prosthesis Avoid Over-dimensioned Crowns No clinically noticeable loosening bending movements, exceed more than No pain in the vicinity of the implant No implant mobility under reverse torque testing Gingiva level Biological width (2.5 mm) No radiographic visible peri-implant gap Bone level exceed d ⁄ 2 overhang (d = implant diameter) Stabilisation and primary blocking from the implant itself. ecuring the prosthesis against S pulling and levering forces Force distribution Resilience compensation through Multi-tooth restorations Position implants parallel to each other (a divergence...

Open the catalog to page 3

All Z-Systems AG catalogs and technical brochures

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list