FURNACE EQUIPMENT sintering furnace s'zubler dental&technik

for speed and conventional sintering 5 + 1 freely programmable heating ramps Technological advantage for a safe sintering process INDIVIDUAL SINTERING PROCESS Time and energy efficiency play an important role in the modern dental laboratory. Therefore not only conventional sintering cycles, but also speed processes can be programmed in the S400 in order to be able to work with the greatest cost-effectiveness. All heating phases (maximally five) allow the free input of a heating rate from 1 °C to 100 °C/min. The sum of all holding times is 420 minutes at the most. MOLYBDENUM DISILICIDE HEATING...

2 LEVELS OF SINTERING DISHES WITH LARGE FIRING CHAMBER MINIMIZED COSTS OF THE S400 IN DAILY OPERATION Only the use of suitable dishes in the sintering process ensures high-quality zirconium oxide frameworks whilst at the same time protecting against discolouration or other forms of contamination. The newly developed Zubler sintering dish system is characterised by special material properties that have proven to be very resistant even with extreme changes of temperature. The raw materials familiar from the industry prevent discolourations of the sintering objects caused by chemical reactions....

Linear cooling process thanks to innovative lift system and intelligent software! The quality of zirconium oxide is influenced in no small way by the cooling process after sintering. The perfect solution to this is offered by the TTC program mode, in which the electronics returns the objects linearly to the cycle-end temperature at a freely selectable cooling rate. In order to avoid the temperature dropping too quickly to the end temperature at the end of the holding time, the electronics compensates the high heat losses through targeted reheating. In this way the objects can be cooled to 800...

Scope of delivery: Technische Daten: 1 VARIO S400 sintering furnace 1 mains cable 1 USB flash drive 1 operating manual 1 Tongs for sinter bowls 1 sinter pearls (2 x 40 g) Dimensions (W x H x D) Weight Voltage Power Firing chamber volume Control accuracy at 1500 °C Closing mechanism 330 mm x 830 mm x 570 mm 55 kg 220 V - 240 V ~ 50/60Hz 1900 W 130 x 290 mm for two sinter bowls +/- 3 °C electrical lift system Subject to technical changes. --zublef dental&technik Zubler Geratebau GmbH Buchbrunnenweg 26 D - 89081 Ulm-Jungingen