Inner tube
1 / 3Páginas

Datasheet : Coating : Inner Inner tube Outer cable : Torque coil, ACT ONE, etc. Inner tube : Fluoropolymer and PEBAX layer Fluoropolymer layer PEBAX layer for bonding The Inner tube is designed for internal coating applied to hollow cable tubes like ACT ONE, Torque coil, or Wire coil for adding lubricity, chemical isolation, or surface preparation to the inside of the hollow cable. Ideal for applications requires lumen lubricity, sealing, or chemical resistance, for customers developing a delivery system. Specifications Minimum wall thickness (including Fluoropolymer and PEBAX layer) *It depends on Inner tube ID as below, which is not include tolerance. Inner tube ID Min. wall thickness 0.20 - 0.73 mm 0.03 mm 0.74 - 1.01 mm 0.04 mm 1.02 - 1.29 mm 0.05 mm 1.30 - 1.57 mm 0.06 mm Inner tube ID Min. wall thickness 1.58 - 1.85 mm 0.07 mm 1.86 - 2.13 mm 0.08 mm 2.14 - 2.33 mm 0.09 mm 2.34mm ～ N/A Coating material (Fluoropolymer layer) - PTFE - PFA - FEP - ETFE greatest lubricity and chemical resistance similar in chemical resistance to PTFE, but less lubricity similar to PFA, slightly less susceptible to water absorption than others greatest strength and abrasion resistance End treatment of inner tube manually cut using utility knife End treatment of outer cable

Product lineup Specifications and Comparison of properties OD(mm) ID(mm) standard flat ultra thin auger* Torque Hypotube Wire coil OD(mm) ID(mm) bi-directional (3 layers) or unidirectional (2 layers) 4 rotation *Archimedes screw with spiral wire high breaking strength and elongation resistance well balanced properties *Archimedes screw with spiral wire high flexibility 5 and compression resistance Torque force Hollow cable Torque coil 1to1 Torque response High-speed rotation Drive Cable Optimized for high speed 2 rotation and power transmission Torque rope 1:1 torque transmission at...

Datasheet : Coating : Outer Outer coating A stainless steel cable assembly may be sprayed, dipped, or extruded with PTFE, Nylon, and other coatings for your particular abrasion-resistance, lubricity, low coefficient of friction, and long-term durability requirements. Asahi Intecc can precisely mask the ends of the coated stainless steel cable assemblies to attach various in-house iron (FE), stainless steel (SUS, SS), Aluminum (AL), Copper (Cu), and other metallic finishes. Comparison of properties Type Heat Chemical Cost Flexibility Lubricity resistance (1=lowest) resistance Minimum...