UBREATH Breath Gas Analysis System BA200 Operation Guide
4Páginas

Quick Installation Guide Installation of sensor 1 Disassemble the instrument back panel Carefully place the instrument on a flat and stable table, unscrew the screws on the back panel of the instrument, remove the back panel. Preparation sensor Check the sensor aluminum can package if sealed well. Open the sensor can carefully. The inside of the opening may have sharp edges. According to the instructions of the slot, put the corresponding Sensor into the slot. Rotate the yellow swivel knob locking device clockwise until locked. The up arrow on the knob needs to be aligned with the down arrow on the notch. Open the back cover of the instrument, insert the battery connector plug into the battery connector socket in the direction indicated by the positive and negative poles (red for positive, black for negative) and then place the battery into the battery compartment. If the instrument will leave unused for a long time, it is important to disconnect the battery and It is recommended that it is charged every six months. Starting up and setting 1.Powering on Press and hold the power button, the instrument will be turn on and run self-acting check. 2.Setting Click the “Settings” button at the bottom of homepage to run for system setting. Do not touch or clean the white sensor film at bottom side. The sensor must be stored in the original unopened package or installed in a UBREATH® Breath Gas Test System. Installation and disassembly of handle Installation: Insert the tube of the breathing handle into the breathing handle port & make sure it connected closely. Disassembly: Press and hold the ring of the instrument, while holding the air tube and pulling it out. Pulling out the tube directly may cause damage to the instrument. Please keep the cap on the breathing handle when the instrument is u

Quick Installation Guide Printer connection The printer can be connected via three ways as: 1.WIFI 2.LAN 3.Direct via USB print port on the instrument by OTG cable. Product Maintenance Guide Change battery 1. Turn off the instrument , open the battery cover and remove the old battery. 2. Insert a new battery, model LP606090x2, Prefer to the “Installation of Battery” of Quick Installation Guide for detail. Change sensor 1. Disassembly the instrument back panel 4. Installation of back panel Please refer to the “Installation of sensor”of quick installation guide or use manual for details....

Quick Measurement Guide Online FeNO testing Installation of patient filter Powering on the instrument Login to the account Click the “clean” to empty inner air path. Automatically jumps back to the homepage when the inner air path has been emptied. Remove the cap of breathing handle, insert the patient filter into the breathing handle, and make sure it linked closely. On-line oral breath measurement 1 Enter patient's Info Patient information entry can be done by enter patient information manually, selecting the existing patient and other method. Click "FeNO" button, then fill the physician...

Quick Measurement Guide Online FnNO testing Installation of nasal filter 1. Press and hold the ring at the handle joint , then remove the air tube. 2. Insert the nasal filter into the air tube and check if it link tightly. FnNO test standard procedure 1 Enter patient's Info Click "FnNO" button, then fill the physician information and check with patient information and precautions. Click "Save" button to prescribe a FnNO test. Patient information entry can be done by enter patient information manually, selecting the existing patient and other method. Remark: The function of single test or three...