QA-ES III Electrosurgical Analyzer and Tester
1 / 6Páginas

Technical data Biomedical The QA-ES III Electrosurgical Analyzer simplifies testing to ensure the performance and safety of electrosurgical units. With generator output current accuracy as low as ± 2.5 %, the QA-ES III is capable of testing all modern high power electrosurgical units. Collect all measurements including vessel sealing, contact quality monitor (CQM), high frequency (HF) leakage and output power distribution in single or continuous mode. The QA-ES III has all hardware and software needed for complete testing, so you don’t need to carry additional accessories or cables. With all-in-one features, the QA-ES III is one of the most user-friendly electrosurgical analyzers on the market today. Additionally, Ansur test automation software allows users to create and automatically run tests, capture data, and produce easy-to-read reports. Key features • Test all critical ESU functions with precise power, current, frequency, crest factor and load resistance ranges • Collect measurements in single and continuous mode • Automatic power distribution measurement, including power, current, peak-to-peak voltage, and crest factor • All-in-one tool: all hardware and software necessary to complete preventive maintenance and troubleshooting is built in to the unit, eliminating the need to purchase or transport additional cables, leads, switch boxes and RECM box • User-friendly interface: large buttons and LCD screen guide the user through test sequences • Memory storage of up to 5,000 test records, eliminating the need to download data after the completion of each preventive maintenance or troubleshooting session • Complies to all global standards, including ANSI/AAMI and I EC1 Bipolar leakage testing performed with 200 ohm fixed load.

Modes of operation Continuous operation Power distribution CQM Continuous measurement of power, current, peak-to-peak voltage (closed load only), and crest factor. Single operation Single measurement after the set delay time of the ESU output of power, current, peak-to-peak voltage (closed load only), and crest factor. Automatic measurement of power, current, peak-to-peak voltage (closed load only), and crest factor through a user-selectable load range. HF leakage current Provides connections and load configurations to measure HF leakage from both grounded and isolated equipment. Perform...

Wireless module listing Measurements and tests specifications Duty cycle Generator output measurements Vessel sealing measurement 3 Fluke Biomedical QA-ES III Electrosurgical Analyzer

Specifications (continued) HF leakage current Fixed load V Accuracy Power rating Additional fixed load Current, RMS Accuracy CQM test (Contact Quality Monitor) Resistances Accuracy Power rating Auto time interval Oscilloscope Output 1 V per ampere of input current, typical Footswitch simulations Cut and Coag Communications USB device port Micro B connector, full speed Memory Test records Non-volatile 5,000 retained through power cycling Calibration Recommended cycle Traceable to the International System of Units (SI) through the appropriate National Metrology Institutes such as NIST or...

5 Fluke Biomedical QA-ES III Electrosurgical Analyzer

About Fluke Biomedical Fluke Biomedical is the world’s leading manufacturer of quality biomedical test and simulation products. In addition, Fluke Biomedical provides the latest medical imaging and oncology quality-assurance solutions for regulatory compliance. Highly credentialed and equipped with a NVLAP Lab Code 200566-0 accredited laboratory, Fluke Biomedical also offers the best in quality and customer service for all your equipment calibration needs. Today, biomedical personnel must meet the increasing regulatory pressures, higher quality standards, and rapid technological growth,...