Excertos do catálogo
TGM3series Product Segments • Ergo Motion • Industrial Motion The TGM3 series is TiMOTION's compact size gear motor. It was designed primarily for ergonomic applications like height adjustable workstations and tables, but can be used in many other applications. This economical product allows for fast, smooth and quiet adjustment of built-in spindles through the use of external limit switches. Shafting allows for the mechanical synchronization of dual spindles. General Features Voltage of motor Maximum speed Maximum rated torque Operational temperature range at full performance Options Hall sensors Hexagon hole for the shaft by 6mm diameter Low noise
Abrir o catálogo na página 1Drawing Standard Dimensions -Without TES2 (mm) Standard Dimensions -With TES2 (mm) Load and Speed CODE Torque Load (Nm) Self Locking Force (Nm) Typical Current (A) Typical Speed (RPM, ±5%) Hall Sensor Output No Load With Load No Load 32V DC 24V DC 32V DC With Load Magnet 24V DC Poles Period (ms) No Load With Load Note 1 Please refer to the approved drawing for the final authentic value. 2 The current & speed in table and diagram are tested with TiMOTION control boxes, and there will be around 10% tolerance depending on different models of the control box. (Under no load condition, the...
Abrir o catálogo na página 2Performance Data (24V DC Motor) Speed vs. Torque Load Current vs. Torque Load
Abrir o catálogo na página 3Performance Data (24V DC Motor) Speed vs. Torque Load
Abrir o catálogo na página 4Output Signal 0 = Without 2 = Hall sensor * 2 Plug 0 = Tinned leads 1 = DIN 6P, 90° 2 = Molex 8P See page 6 Cable Length (mm) 0 = Straight, 1000 1 = Straight, 1500 2 = Straight, 2000 External Limit Switch 0 = Without 1 = With Output Rotation XX = Number of output rotations (between13~17 & 25~35 rotations, factory preset)
Abrir o catálogo na página 51 = DIN 6P, 90° plug 2 = MOLEX 8P, plug 50 Note 1 The combinations of TGM and TBS are marked as "v" on the above table. 2 When choosing the combination of TBS2 / 3 and TGM7, the hexagonal drive shaft is not required. 3 When choosing the combination of TBS1 / 4 / 5 / 9 / 10 and TGM1 / 3 / 4, the extra order of hexagonal drive shaft is needed. 4 Please refer to the table below for the serial numbers and the dimensions of the component. Hexagonal drive shaft The user is responsible for determining the suitability of TiMOTION products for a specific application. TiMOTION products are subject to...
Abrir o catálogo na página 6Todos os catálogos e folhetos técnicos TiMOTION Technology
-
ACTUATION SYSTEMS FOR DENTAL DEVICES
4 Páginas
-
ERGO MOTION
48 Páginas
-
CARE MOTION
32 Páginas
-
series TL3
12 Páginas
-
JP4 series
7 Páginas
-
TA41 series
11 Páginas
-
JP3 series
7 Páginas
-
TA6 Series
10 Páginas
-
TA1 Series
12 Páginas
-
TGM2 Series
7 Páginas
-
TGM1 series
7 Páginas